Battery Compartment - Teac SL-D930 Manual Del Usuario

Ocultar thumbs Ver también para SL-D930:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

A
PHONES jack
To listen with headphones, first minimize the volume.
Then, insert the headphones' plug into the PHONES
jack and gradually increase the volume. No sound will
be output from the speakers while the headphones'
plug is inserted in the PHONES jack.
V CAUTION
Always turn the volume down before plugging
in headphones and putting them on. Do not
connect or disconnect headphones or turn the
unit on or put it in standby while wearing them.
Sudden loud noises could occur, which might
cause hearing damage.
B
AUX IN jack
You can connect a portable audio player to this jack.
Connect it to the audio output jack (LINE OUT or
PHONES) of the player using the included stereo mini
plug cable.
o When using the PHONES jack of an audio player,
you must also adjust the volume of that audio
player or you might hear no sound from this unit.
o If you raise the volume level of the connected
device too high, the sound might distort. If this
occurs, lower the volume of the connected device
until distortion stops and then adjust the volume
on this unit.
C
FM antenna
Extend the lead to find the best position for FM broad-
cast reception.
This antenna may need to be repositioned if you
move your unit to a new location.
D
AC power cord
After completing all other connections, plug the
power plug into the power outlet.
Unplug the power cord from the outlet when you are
not planning to use the unit for an extended period
of time.
V CAUTION
Be sure to connect the power cord to an AC out-
let that supplies the correct voltage. Connection
to an outlet that supplies incorrect voltage could
cause fire or electric shock. Hold the power plug
when plugging it into an outlet or unplugging it.
Never pull or yank on the power cord.
E

Battery compartment

This contains a battery used to temporarily back up
the unit's clock, FM/AM radio station presets and
wakeup timer settings during power outages and
when the power cord is unplugged.
Battery installation
Loosen the battery cover screw. Push the other end of
the cover to open the compartment. Insert a CR2032
lithium-ion battery with the positive ( ¥ ) side facing
the cover. Close the cover.
When to replace the battery
If the clock begins to indicate the wrong time, replace
the battery with a new one.
Dispose of the used batteries according to the instruc-
tions on them or requirements set by your local
municipality.
V CAUTION
Misuse of batteries could cause them to rupture
or leak, which might result in fire, injury or the
staining of nearby materials. Please read and
observe the precautions on page 3 carefully.
15
15

Publicidad

Tabla de contenido
loading

Tabla de contenido