Samsung U Flex Manual Del Usuario página 557

Connecting via Bluetooth
Connecting additional devices
The headset can connect to up to two Bluetooth-enabled devices at the same time. When
you connect the headset to two devices, the last device you connect is recognized as the
primary device. The other device is recognized as the secondary device.
1
Connect the headset to a device via Bluetooth.
2
Slide the Power switch to the right and hold it for approximately three seconds to enter
Bluetooth pairing mode.
The first device will be disconnected.
3
Connect the headset to a second device.
4
Reconncet the headset to the first device from the first device's Bluetooth settings screen.
This feature may not be supported on some devices.
Reconnecting or disconnecting the devices
Reconnecting the devices
If the Bluetooth connection ends due to the distance between the devices, bring the devices
closer together within a certain period of time. The devices will automatically reconnect.
If the Bluetooth connection ends because of a device malfunction, access the Bluetooth
menu on the connected device to pair them again.
Disconnecting the devices
Slide the Power switch towards and hold it for approximately three seconds. Then, the
connection ends and the headset enters Bluetooth pairing mode.
You can also end the connection by turning off the headset. When you turn on the headset
again and the devices are in range, the headset automatically connects with the most
recently paired device.
Noise may occur if the Bluetooth connection is disconnected improperly.
English (USA)
9