Sears Kenmore 385.17628 Manual De Instrucciones página 32

o
Inserting the Bobbin
m
C) End of thread
(_ Notch
(_ Notch
Q Threading chart
Place a bobbin in the bobbin holder with the
thread running off counterclockwise°
[] Guide the thread into the notch (_) on the front
side of the bobbin holder° Draw the thread to the
left, sliding it between the tension spring blades,.
[] Continue to draw the thread lightly until the
thread slips into the notch (_). Pull out about 6"
(15 cm) of thread.
[] Attach the hook cover plate° Check the threading
by referring to the chart (_) shown on the hook
cover plate.
f
[]
[]
[]
[]
7
24