Button Sewing - Sears Kenmore 385.17628 Manual De Instrucciones

Button Sewing
(_) Stitch width: 2 to 65
O Stitch length: Any
(_) Needle thread tension: 2 to 6
(_) Presser foot A: Zigzag foot
(_ Feed dogs: Dropped
Drop the feed dogs. Match the holes on a button
with the horizontal slot on the presser foot [A]. Ad-
just stitch width matching the distance of the holes
on the button. Lower the foot to hold the button in
place. Check to see if the needle enters into the
holes on the button by turning the handwheel by
hand, Sew about ten (10) stitches.
To strengthen the shank, cut the threads leaving
about 4' (10 cm)o Bring the needle thread down
through one of the holes on the button and wind it
around the shank° Bring the needle thread to the
wrong side of the fabric and knot the threads° After
button sewing is completed, raise the feed dogs for
normal sewing.
Overcasting Stitch
(_ Stitch width:
Stitch length:
(_) Needle thread tension:
(_ Presser foot A:
(_) Presser foot C:
5 to 6.5
Red zone
3to 8
Zigzag foot
Overedge foot
Note:
Set the stitch width from 5°0 to 6,5 when the
overedge foot C is used to prevent needle breakage
or damaging the foot°
This is useful in garment construction and in
finishing raw edges of any sewing projecL
Start overcasting about 1/8 °' (0.3 cm) inside the raw
corner of a seam. If you start right at the edge, the
fabric bunches up and the stitches become tangled°
'_' Gently guide the fabric so that the raw edges
always touch the black ridge and brush guide,
(_ Black ridge and brush guide
(_) Edge of fabric
® ®
f
¢"
LENGTH ®
® ®
or
°
O U
........ J
54