Removing/Assembling the
Freezer Drawer Handle
Removing the Handles
1
Loosen the set screws
lower side of the handle with a
wrench and remove the handle.
2
Loosen the mounting fasteners
connect to the
freezer drawer
and handle
1
using a
/
in.
4
Allen wrench,
and remove
the mounting
fasteners.
Assembling the Handles
1
Assemble the mounting fasteners
both ends of the handle using a
wrench.
2
Place the handle on the door by fitting
the handle
footprints over
the mounting
fasteners and
tightening the
set screws
1
with a
/
in.
8
Allen wrench.
WARNING
When the customer takes apart the handle
or assemble it from a refrigerator, please be
cautious of following things.
Hold the handle with your own hand to
make sure not to drop the handle to the
floor or instep while taking apart the handle
from a refrigerator.
Do not swing the handle towards people or
animals after taking apart the handle.
Insert the bracket hole of the handle into
the stopper bolt of the door exactly, and
then assemble the set screws to fix the
handle.
Check if there's any gap between the door
and handle after fixing the handle.
Removing/Assembling the
Doors and Drawers
Removing the doors is always recommended
when it is necessary to move the refrigerator
located on the
through a narrow opening.
1
/
in. Allen
8
that
at
1
/
in. Allen
4
Removing the Left Refrigerator Door
1
INSTALLATION
WARNING
If your entrance door is too narrow for the
refrigerator to pass through, remove the
refrigerator doors and move the refrigerator
sideways through the doorway.
Use two or more people to remove and
install the refrigerator doors. Failure to do
so can result in back or other injury.
Disconnect the electrical supply to the
refrigerator before installing. Failure to do
so could result in serious injury or death.
Do not put hands, feet or other objects into
the air vents or bottom of the refrigerator.
You may be injured or receive an electrical
shock.
Be careful when handling the hinge and
stopper. It may result in injury.
Remove food and bins from the doors and
drawers before detaching.
The water supply is connected to the
upper right part of the rear surface of the
refrigerator. Remove the ring in the joint
area. Hold the water supply connection
and gently push the Collet to detach the
water supply line as shown in
Collet
NOTE
Detachment of the water supply line is
applicable only when detaching the left
refrigerator door.
13
and
.