Electrical Safety; Assembly; The Curved Handle And Wheels - FLORABEST FRM 1200 D3 Manual De Instrucciones

CAUTION! The following
states how to avoid accidents
and injuries due to electric
shock:

Electrical Safety:

• Ensure that the mains voltage
matches the specifications on
the rating plate.
• If possible, connect the equip-
ment only to a socked with a
residual current-operated protec-
tive device (RCD) with a release
current of more than 30 mA.
• Avoid bodily contact with
earthed parts (e.g. metal fenc-
es, metal posts).
• Use only authorised power
cables of type H05RN-F, which
are no more than 75 m long
and suitable for outdoor use.
The power cable wire cross sec-
tion must be at least 2.5 mm
Always completely unroll cable
drums before use. Check the
cable for damage.
• To fix on the power cable, use
the cable suspension intended
for the purpose.
• Keep the power cable away
from the cutting tool when work-
ing. The cutting blades may
damage the power cable and
result in contact with live parts.
Always run the power cable be-
hind the operator.
• Do not use the power cable to
pull the plug from the socket.
Protect the power cable from
heat, oil and sharp edges.
• Switch off the equipment and
disconnect the plug from the
socket if the power cable is
damaged. If the power cable is
damaged, it must be replaced
by the manufacturer, the cus-
tomer services of the same, or
a qualified person, in order to
avoid hazards.
• Do not connect a damaged
power cable to the mains. Do
not touch a damaged power
cable when it is connected to
the mains. A damaged power
cable may result in contact with
live parts.

Assembly

Disconnect the plug before any
work on the equipment. There is a
risk of injury.
Assembling the Curved Han-
dle and Wheels
.
B
2
1. Insert the lower bar (3) into the
slot on the lawnmower housing
(6). Compare with the figure
2. Fix the bar (3) using the en-
closed screws (13).
3. Screw all four wheels (5) with
the fittings (5.1) onto the lawn
mower housing (6). The single
wheel adjustment has always to
be at least at one axis.
C
4. Fix the curved handle (1) using
the enclosed screws (14) and the
wing nuts (2) on the lower bar
(3). There are two possible posi-
tions.
5. Clip the cable holder (see
8) into the bar (3) and to the
curved handle (1) and thus fix
the cable.
G B I E
A
.
A
2 5