To Unload A Cd; Basics Of Using The Cd Player-Normal Play; Search Play; Programming The Playing Order Of The Tracks - JVC FS-SD5 Manual De Instrucciones

To Unload a CD

Take out the CD as shown below.
Basics of Using the
CD Player-Normal Play
To Play a CD
1
Insert a CD.
Press the CD #¥8 button.
2
The first track of the CD begins playing.
Track number
• The track number that has already played disappears
from the music calendar.
• The CD Player automatically stops when the last
track of the CD has finished playing.
To stop playing the CD, press the 7 button.
The following information for the CD is displayed.
Total track number
To stop playing and remove the CD, press the
OPEN/CLOSE button on the Unit or CD 0 button on the
Remote Control to open the Top Cover.
Playback time
Total playback time
To pause, press the CD #¥8 button. The playback time
blinks on the display.
To cancel pause, press the same button again. Play con-
tinues from the point where it was paused.
To Select a Track or Passage within a Track
During playback, press the 4 or ¢ (< or >) button to se-
lect the track you want.
• The selected track starts playing.
• Press the ¢ or > button once to skip to the begin-
ning of the next track.
• Press the 4 or < button to skip to the beginning of
the track being played. Press twice quickly to skip to
the beginning of the previous track.
• When the > or < button on the Remote Control is
kept pressing, the track continuously skips.

Search Play

Holding down the 4 or ¢ button, during playback, will
fast forward/backwards the CD so you can quickly find a
particular passage in the track you are listening to.
Programming the
Playing Order of the Tracks
You can program the playing order of the tracks using the
Remote Control.
You can program up to 32 tracks in any desired order in-
cluding the same tracks.
You can only make a program when the CD Player is
stopped.
1
Insert a CD.
Press the CD #/8 button.
2
Press the 7 button to stop the CD.
3
4
Press the PROGRAM button.
The System enters the programming mode and the
"PROGRAM" indicator lights up.
PROGRAM
PROGRAM
5
Press the UP, DOWN, >, or < button to
select the track to program.
UP or > button: Increases the track number by 1.
DOWN or < button:Decreases the track number by 1.
• When the > or < button is kept pressing, the track
number changes rapidly.
(To be continued on the next page)
Using the CD Player
14