Instruction For Changing The Falmec Radio Con- Trol - FALMEC GRUPPO 3330 Manual De Instrucciones

ETSI EN 300 220-2 V2.1.2 (2007-06) EN 60950-1 (2001)
ETSI EN 301 489-1 V1.4.1 (2002)
ETSI EN 301 489-3 V1.4.1 (2002)
INSTRUCTION FOR CHANGING THE FALMEC RADIO CON-
TROL
Disconnect the device from the mains.
To enter in the "change code mode" the button "Luce" and "Timer" (re-
mote control) must be pressed together for more than 3 seconds. After 3
seconds the LED starts flashing slowly. Now, if you press the button "-"
(remote control) within 5 seconds a new code is generated in casual mode
and memorized within the radio control. The memorizing is confirmed by
3 quick LED flashings.
To get back to the default code: press "-" and "+" (remote control), toge-
ther for more than 5 seconds. After 5 seconds, the default code is memori-
zed within the radio control. The memorizing is confirmed by 3 quick LED
flashings. Plug the device to the mains and check that lights and motors
are off. Press the timer button on the push-button panel for 2 seconds and,
when the red LED lights up, press any of the radio control's buttons within
10 seconds. With this operation a new transmission code is registered.
H
FILTERS
1. METAL FILTERS
- Open the panel (see fig. H1). Use handle to remove the metal grease filter.
2. CHARCOAL FILTERS
To replace the charcoal filters, proceed as follows: remove the metal filters
as described above. The two filters located at the ends of the motor can now
be easily accessed.
To install the new fi lters see picture.
In case of hood with the motor box the fi lter is located on the botton part of
the motor box.
To install the new fi lters see picture.
To order new charcoal fi lters contact the distributor/retailer.
VALID ONLY FOR ITALY: download the appropriate order form from: www.
falmec.com (access the assistance drop-down menu).
18
(to be used only in the case of malfunction due to interferences)
REMOVING AND REPLACING'S INSTRUCTIONS
EN 50371 (2004-06)