Makita 5477NB Manual De Instrucciones página 8

CAUTION:
Be sure the blade is installed with teeth pointing up
•
at the front of the tool.
Use only the Makita hex wrench to install or
•
remove the blade.
To remove the blade, press the shaft lock so that the
blade cannot revolve and use the hex wrench to loosen
the hex bolt clockwise. Then remove the hex bolt, outer
flange and blade.
To install the blade, follow the removal procedure in
reverse. BE SURE TO TIGHTEN THE HEX BOLT
COUNTERCLOCKWISE SECURELY.
1
2
3
009230
When changing blade, make sure to also clean upper
and lower blade guards of accumulated sawdust. Such
efforts do not, however, replace the need to check lower
guard operation before each use.
CAUTION:
One side of the inner flange is for 5/8" hole
•
diameter of the blade and the other side is for
13/16" hole diameter. Use the correct side for the
hole diameter of the blade you intend to use.
Mounting the blade on the wrong side can result in
dangerous vibration.
2
1
6
007400
OPERATION
CAUTION:
Be sure to move the tool forward in a straight line
•
gently. Forcing or twisting the tool will result in
overheating the motor and dangerous kickback,
possibly causing severe injury.
1. Ring 17
2. Inner flange
5
3. Saw blade
4. Outer flange
4
5. Hex bolt
1. Ring 17
3
2. Inner flange
4
3. Blade
5
4. Outer flange
5. Hex bolt
6. Mounting shaft
1
009232
Hold the tool firmly. The tool is provided with both a front
grip and rear handle. Use both to best grasp the tool. If
both hands are holding saw, they cannot be cut by the
blade. Set the base on the workpiece to be cut without
the blade making any contact. Then turn the tool on and
wait until the blade attains full speed. Now simply move
the tool forward over the workpiece surface, keeping it
flat and advancing smoothly until the sawing is
completed.
To get clean cuts, keep your sawing line straight and
your speed of advance uniform. If the cut fails to properly
follow your intended cut line, do not attempt to turn or
force the tool back to the cut line. Doing so may bind the
blade and lead to dangerous kickback and possible
serious injury. Release switch, wait for blade to stop and
then withdraw tool. Realign tool on new cut line, and
start cut again. Attempt to avoid positioning which
exposes operator to chips and wood dust being ejected
from saw. Use eye protection to help avoid injury.
Rip fence (Guide rule) - optional accessory
009233
The handy rip fence allows you to do extra-accurate
straight cuts. Simply slide the rip fence up snugly against
the side of the workpiece and secure it in position with
the screw on the front of the base. It also makes
repeated cuts of uniform width possible.
8
1. Front handle
2. Rear handle
3. Base
2
3
1. Rip fence (Guide
rule)
1