DURAVIT SensoWash D-CODE Manual De Instrucciones página 49

Problem
Seat or water tem-
perature not set.
Seat or water is
not warm.
Seat unit overheated.
Potential cause Solution
> Make sure that the seat and
water temperature buttons
are set to "ON ".
> Set the seat and water
temperature to the desired
temperature.
The product is equipped with an
additional bimetal safety device
for the water heater; it switches
the heater off automatically if the
normal temperature is exceed-
ed. If this safety device trips, the
product does not function and
displays an error message until
it has cooled. The bimetal safety
device then resets automatically.
You can restart the product by
pressing any button while the er-
ror message is displayed.
> Press any button to switch the
seat unit on again.
EN
see
sec.
8.7 /
8.8
49