Hilti WSC 7.25-S Manual De Instrucciones página 8

Ocultar thumbs Ver también para WSC 7.25-S:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

To avoid the risk of injury, use only genuine Hilti accessories and insert tools.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
Modification of the power tool or tampering with its parts is not permissible.
2.2 Switches
On / off switch
2.3 Grips
Grip and auxiliary grip
2.4 Protective devices
Blade guard and pendulum-type blade guard
2.5 Lubrication
Grease lubrication
2.6 Items supplied as standard
1
Power tool
1
Saw blade
1
Operating instructions
1
Hexagon socket wrench
1
Parallel guide (rip fence)
1
Hilti cardboard box or toolbox
2.7 Using extension cords
Use only extension cords of a type approved for the application and with conductors of adequate cross section.
The power tool may otherwise lose performance and the extension cord may overheat. Check the extension cord for
damage at regular intervals. Replace damaged extension cords.
Recommended minimum conductor cross section and max. cable lengths
Conductor cross section
Mains voltage 120 V
Do not use extension cords with 10 AWG, 16 AWG or 18 AWG conductors.
2.8 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this application.
2.9 Using a generator or transformer
This power tool may be powered by a generator or transformer when the following conditions are fulfilled: The unit
must provide a power output in watts of at least twice the value printed on the type identification plate on the power
tool. The operating voltage must remain within +5% and -15% of the rated voltage at all times, frequency must be in
the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with automatic voltage regulation and
starting boost.
Never operate other power tools or appliances from the generator or transformer at the same time. Switching other
power tools or appliances on and off may cause undervoltage and / or overvoltage peaks, resulting in damage to the
power tool.
14 AWG
25 ft
12 AWG
50 ft
en
3

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido