Heat Panel, Deflector; Handles And Latches - Louisiana Grills Champion Serie Instrucciones Y Uso

Installation:
Place the upper cabinet on a table or solid working space, to make
installation easier.
• Screw the chimney cap through the adjustable damper and into
the chimney base.
• Ensure to leave at least one 25 mm, (1"), distance between
the top cap and the chimney base.
• Ensure the adjustable damper works freely.
• Line up the felt gasket to the holes provided on the top of the
upper cabinet.
• Place assembled adjustable chimney assembly on top of the gasket.
• Using a Phillips Screwdriver install the four (4) Phillips screws, spring
washers and washers, to securely mount the assembly to the upper
cabinet.
9 INSTALL REAR HEAT PANEL
Parts Required:
1 x Upper Cabinet
1 x Rear Heat Panel
4 x Phillips screws (D)
4 x Spring washers (F)
4 x Washers (G)
Installation:
From inside the Upper Cabinet, use a Phillips screwdriver to install the
4 screws, spring washers and washers needed to secure the rear heat
shield to the cabinet.
10 INSTALL REAR EXHAUST CONTROL
Parts Required:
1 x Upper Cabinet
1 x Rear Exhaust Control Panel
Installation:
• Remove the four (4) screws pre-installed on the back of the
upper cabinet.
• Line up the four (4) holes on the rear exhaust control panel with
the four (4) holes provided on the upper cabinet, hand start the
screws, tighten using a screwdriver.
11 INSTALL DOOR HANDLES AND LATCHES
Parts required for each cabinet door:
4 x Stainless Steel Handle with
2 x Phillips Screws
8 x Bezel - Decorative Washer
2 x Twist locking door assemblies
13