Cleaning And Maintenance - HSM securio B 24 Instrucciones De Servicio

7 Cleaning and maintenance

WARNING
Dangerous mains voltage!
Switch off the shredder and pull
out the mains plug.
When cleaning only use a soft cloth and a
mild soap-water solution. However, no water
must enter the equipment.
Check that the container contact is work-
ing properly
WARNING
If the following procedure cannot
be performed, switch off the docu-
ment shredder, disconnect the
mains plug and contact customer service.
• Insert the mains plug and switch on the
shredder.
• Feed in a sheet of paper and tilt out the
container while the paper is being drawn in.
The cutting unit must switch off immedi-
ately and the "container open" indicator
must light up.
• Insert the shredded material container
again fully.
The cutting unit must not yet restart.
• Pull the paper out of the feed opening.
The light barrier must be clear.
• Switch off the machine and then switch
back on.
The cutting unit starts when paper is fed in.
16
container (Cross cut only).
unit oil through the paper feed along the
entire width of the cutting shafts.
• Let the cutting unit run in the permanent
mode for about 10 seconds without any
paper.
Paper dust and particles are shaken off.
Note
Oiling the cutting unit also improves the cut-
ting performance of devices with strip cut.
8 Disposal / Recycling
Electrical and electronic old de-
vices contain a variety of valuable
materials, but also hazardous
substances which were required
for function and safety. Incorrect
disposal or handling can be dan-
gerous to your health and the environment.
Never dispose of old devices in the house-
hold waste. Observe the current applicable
regulations and use the collection points for
returning and recycling electric and elec-
tronic devices. Dispose of all the packaging
materials also in an environmentally-respon-
sible way.
SECURIO B 24
english
Oil the cutting unit when
cutting performance de-
creases or the device
becomes noisy, or every
time you empty the waste
Only use HSM special
lubricating oil for the
cutting unit to do this:
• Spray the special cutting
09/2011