Using The Device - Clatronic DB 2709 Instrucciones De Servicio

4....-05-DB 2709
• Clean the ironing base with a slightly damp cloth.
GB
• Fill the water tank through the filling hole (6) with normal water (up to a
hardness degree of 2). In case of water with a higher degree of hardness, use
distilled water. Use the filling container.
ATTENTION: Only garments are to be ironed with this device.
Ironing without steam (steam jet regulator on 0).
1. Place the device on its stand.
2. Electrical connection
Make sure that the iron voltage (see name plate) and the line voltage match.
3. Sort the laundry according to ironing temperature. Start from the lowest
temperature to be set with the thermostat:
• synthetics, silk
• • wool
• • • cotton, linen
4. Insert the plug in a duly installed 230V/50Hz socket with protective contact.
5. The LED lights up. As soon as it shuts off, the set temperature is reached
(approximately 3 min.). Now you can start to iron.
6. Always pull the plug out of the socket after using the iron.
Steam ironing
• Open the filler opening. Then fill the tank with water and close the filler hole.
• For this a high temperature is needed (cotton, linen).
• The quantity of steam can be regulated using the steam quantity regulator (5).
• Extra steam can be added with the steam jet function (9).
Vertical Steam: This can be used to produce a jet of steam in a vertical direction.
Self-Clean (
1. Fill about half the water tank with water.
2. Heat the device to the max. temperature. When the LED shuts off, unplug the
device.
3. Now hold the machine horizontally above a sink, turn the steam quantity control
to the self-cleaning symbol and rock it to and fro until the tank is empty. Then
turn the control back to "0".
4. Place the iron back on the stand and heat it again. To clean the soleplate, pass
the iron on a clean cotton cloth.
Spray function
to dampen a spot to be ironed, press the spray button (5).
28
07.05.2002 10:04 Uhr

Using the Device

(low temperature)
(medium temperature)
(high temperature)
)
Seite 28