Attachments - Stiga SP 316 Manual De Instrucciones

PROBLEM
5. If the engine floods
6. No oil is released
7. The chain moves
when the engine
is running idle
8. The machine starts
to vibrate abnormally
9. The machine has
struck a foreign body.
If problems persist after having performed the above operations,
contact your dealer or an authorised service centre.

16. ATTACHMENTS

The "Correct bar and chain combination table"
contains a list of all possible combinations between
bar and chain, indicating those which may be used
on each machine, marked with the symbol "".
The same table also provides the
specification data for all chains and bars
approved for use on each machine.
Only use the replacement bars
and chains listed in the table. The use
of unapproved combinations may be
hazardous and cause serious injuries to
operators and damage the machine.
In consideration that the selection,
application and use of the bar and chain are
actions made solely by the user, at his own
discretion, the latter assumes responsibility
for damages of any kind arising from such
actions. When in doubt or if lacking knowledge
of the specifics of each bar or chain, contact
your dealer or an Authorised Service Centre.
PROBABLE CAUSE
The starter grip has been
driven repeatedly with
the choke engaged
Poor quality oil
Lubrication holes are clogged
Incorrect adjustment
of fuelling
Damaged or loose parts.
Damaged or loose parts.
Remove the spark plug (par. 8.4) and
gently pull the starter rope hand grip
(Fig. 13.E) to eliminate any excess
fuel; then dry the spark plug electrodes
and remount it on the engine.
When the engine is cold, empty
the tank, clean it and the pipes with
liquid detergent and change the oil.
Clean them (chap. 8.1)
Contact the Authorised
Service Centre or dealer.
Stop the machine and disconnect
the spark plug cable (Fig. 25.A).
Inspect for damage.
Check and tighten any loose parts.
Have all checks, repair work and
replacements carried out by an
authorised service centre or dealer only.
Stop the machine and disconnect
the spark plug cable (Fig. 25.A).
Inspect for damage.
Check for and tighten any loose parts.
Have all checks, repair work and
replacements carried out by an
authorised service centre or dealer only.
EN - 19
REMEDY