Adjust V-Belt Tension; Refuelling - Zipper Maschinen ZI-BTS350 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 37

13.1.3 Adjust V-belt tension:

Remove the screws (1) on the drive
housing and remove the belt guard (2).
Loosen the three screws (3) on the belt
guide.
Turn the block plug (4) set in the
clockwise direction about the optimum
tension of the V-belt.
Tighten the mounting screws (3) firmly.
Attach the belt cover with the screws
(1)
Adjust belt tension after 5 minutes of idling.
During the first day in operation, you should frequently check the belt tension. Belts are correctly
tensioned when it does not just slip under full load. Excessive tension reduces the life of the belt.

13.1.4 Refuelling

The concrete cutting cutter is powered by a gasoline-oil mixture.
For the 2-stroke engine, you need a gasoline-oil mixture with a mixing ratio of 40:1.
When refueling sure that no foreign particles get into the tank.
During refueling the fire, naked flame and smoking prohibited.
Refuel with the engine running or when engine parts are still hot, is
strictly prohibited.
Refuel only outdoors or in well-ventilated areas.
Wipe off spilled fuel immediately.
Fuel is highly flammable!
Use high-quality synthetic oil for heavy-duty two-stroke engines, if you want to make your
mixture itself. Synthetic oil reduces soot and deposits on spark plug in the cylinder, the piston
and the exhaust what the engine lubrication increases, and thus the life of the engine. Ge self-
made mixtures are to consume within 4 weeks.
ZIPPER Maschinen recommends the use of high-quality finished mixtures specifically for heavy-
duty two-stroke engines.
Before each use, shake the tank properly! Otherwise, the risk of damage
to the motor consists of seizures, because it is lubricated at the beginning
too little.
Before each operation:
Check the tightness of the blade, the fixing nut and all other threaded fasteners.
Check the fuel level and refill if necessary (fuel mixture ratio 40:1)
ZIPPER MASCHINEN GmbH
ZI-BTS350
www.Zipper-Maschinen.at
H I N W E I S
GETTING STARTED
32

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido