Warm Start; Switch Off; Water Supply - Zipper Maschinen ZI-BTS350 Manual De Instrucciones

14.1.2 Warm start

 Press the ON-OFF switch to the ON position.
 Combination switch (2) in the OPEN position on the right. Do not choke on a warm start.
 Engine with pull starter start

14.1.3 Switch off

For a longer life of your engine you let the engine to idle for 3-5 minutes before turning off idle.
 ON OFF switch to OFF position switch.
NOTE:
The length of the starter pull rope is 1.15 meters. Do not pull with great force. When all the rope has
been pulled, the rope is pulled with further train. In addition, it can also mean that the parts are
damaged.
Once you have pulled the rope, should you let it go immediately. One should continue to hold the
hand lever of the starter pull rope and lead it back down.
The rope should be straight up or down to reduce wear.
After the train of the starter pull cord you can roll it slowly.
At this time, when the gasoline engine is not started successfully, it is necessary to press the button
of the decompression valve again to restart.

14.1.4 Water supply

The water connection, you can connect a water supply.
This allows you to achieve a uniform cooling of the blade and reduce the formation of dust strongly.
Operation
 Review safe working environment, safe work clothing, machine before putting on faultless and
operational condition.
 Saw at Max. , align top position, fold down section markers (linkage with red roller) to cut line.
Align the saw blade to cut line.
 gate valve at the bottom of the water tank open.
 Start the engine
 blade wind down slowly deepen the cut until the desired depth of cut is reached.
 Cut only as fast as it allows the material. If the blade lifts the feed, you slow down the feed!
 If desired cutting depth of more than 90mm, this should be achieved through two steps.
 The proper sense of the proper feed speed is important. Please slide the machine fast enough
that the blade can work into the material, but once they realize that the speed decreases, reduce
the feed.
 No lateral pressure on the blade.
 Can not operate without blade guard mounted!
 Do not force the blade into the material. Let the wheel going into the material alone.
 Do not perform long continuous cuts.
 No Dry cutting saw blades are suitable for wet cutting.
 No curves intersect. Not inclined to fix blade material.
ZIPPER MASCHINEN GmbH
ZI-BTS350
www.Zipper-Maschinen.at
OPERATION
34