Operation; Engine Start; Cold Start - Zipper Maschinen ZI-BTS350 Manual De Instrucciones

14

OPERATION

14.1

Engine Start

Place the concrete release cutter safely on the ground. The blade must not be to the ground or other
objects together.
Before the blade, no persons are allowed to stay there.
NOTE: Remove at least 3m from the refueling.

14.1.1 Cold start:

 Press the ON-OFF switch to the "ON" position
 Adjust the combi-switch (2) the corresponding position.
 At restart the combination switch (2) in to be adjusted to the "Choke"
 On a warm start of the ˝Choke˝ is not used. The combi-switch remains in the
 Press with your hand on the handle above the switch (3) of the throttle lever (4). Then push the
throttle lever (4) up.
 Press with your thumb throttle-lock button (5) and leave at the same time the throttle lever to
the lock button can lock.
 Press the the decompression (1) button.
 Hold the front hand lever with one hand and press with your foot to the lateral pedal to the floor.
 Start Cable: Cable tighten until resistance can roll back and then forcefully put in a train.
If the engine according to the third Tightening does not start, open the choke slightly.
 Falls der Motor nach dem 3. Anziehen nicht anspringt, Choke etwas öffnen.
 The combi-switch after the first engine noises flammable placed in the
 If the engine is running throttle lever (4) Press briefly to dislodge the lock button and the full
throttle position is changed to idle.
 Leave for a few minutes without engine load.
 When a load is always at max throttle. Hold speed!
ZIPPER MASCHINEN GmbH
ZI-BTS350
www.Zipper-Maschinen.at
OPERATION
Position.
Position.
ON-OFF switch
position.
33