Maintenance; Maintenance Activities; Spark Plug (Every 50H); Cleaning - Zipper Maschinen ZI-BTS350 Manual De Instrucciones

15

MAINTENANCE

15.1

Maintenance activities

 Check the engine oil level before each use
 Check the belt tension and adjust as required
 Lubricate the bearings of the diamond saw blade axis daily
 Before each use, the blade is in good condition and tight fit
 Before each use the air filter is clean.
 Before each use screw connections for tightness
 Air filter (every 100 hours)
1. Remove the air filter.
2. Clean it in a solution.
3. Drops of engine oil on the air filter.
4. Waste engine oil to remove from the air filter by wring it out.
CAUTION: NEVER WITHOUT ENGINE AIR FILTER OR MAINTAINTED AIR
FILTER WITH NOT OPERATE
15.2

Spark plug (every 50h)

 Remove the spark plug contact.
 Remove any debris with a brush.
 Inspect the spark plug for discoloration.
 Check the contact gap. Standard: 0.7 ~ 0.8mm
15.3

Cleaning

Cleaning: The use of paint thinners, gasoline, corrosive chemicals or abrasive cleaners
will result in damage to the surface!
Therefore:
15.4

Storage

If the machine more than a month is not used, please follow these instructions:
 Entire remove fuel from the tank, fuel cock and carburetor.
 Water from the tap and remove line (this is to do in cold weather after each use)
 Remove spark plug, pour about 1 tablespoon of engine oil into spark plug hole
 Engine switch to the OFF
 Operate starter rope several times
 Spark plug insert
 Generator in a dry, well ventilated place, cover.
ZIPPER MASCHINEN GmbH
ZI-BTS350
When cleaning, use only mild detergent
www.Zipper-Maschinen.at
N O T E
MAINTENANCE
35