motormatic CT-2-24 Manual De Instrucciones página 27

CONEXION CÉLULA FOTOÉLECTRICA
X X +
5
The control units learns the working time during the programming manoeuvre .
To programm the run, you need to have stops on the shutters.
Be sure that gate is equipped with stops and that they are big enough for gate's sizes.
If there is elecktrolock, it is necessary that it is installed on shutter connected
to M1 motor
WORKING TIME AUTOMATIC PROGRAMMING
Before you start with programming, position Trimmer T1 on wished position,
please consider that if you turn the half you will have 70% of motor's strength.
In this way you decide also motor's speed, which is directly proportional to the
strength.
If strength is not sufficient to move the gate, you need to repeat the programming
and increase the strength (if you turn the trimmer in hour sense, strength will increase).
After programming, trimmer T1 will regulate clutch's sensibility. If you turn the trimmer
you can regulate strength form the minimum (programmed) to 100%.
First manoeuvre while programming must be in closure. If it's not, you need to invert
motor's polarity (24V) (blue-red red-blue)
-Set Dip Switch no. 8 on ON
-Push button PP.
Control unit will let start motor M2 and then M1, looking for the stops in closure, after that
there will be an opening manoeuvre, looking for the stops in opening.
-Set again the Dip Switch no. 8 on OFF.
After programming the working time, you must make 2 complete manoeuvres (better
if more) and remember to put Dip Switch no. 9 on ON, so that you can obtain the
worth to regulate the clutch, which can be regulated on Trimmer T1.
-Put Dip Switch no. 9 on ON
-Put button PP and do 2 complete manouevre (close,open-close, and open-close)
-Put Dip Switch no. 9 on OFF.
RX Ft2 Now it is ready for the use, after PP command, it starts to set up
1
the forseen parameters for the wing delay and for the slowing down of the wings.
2
ATTENTION: during programming, clutch is set off!
3
ADVANCED WORKING TIME PROGRAMMING
4
5
With this function you can decide the delay and slowing down times of the wings.
Button P.P. must be used in order to define when let M1 motor start and when to let start
motor M2, after that you can decide the slowing down of motor M1 and of motor M2.
After that the PP button must to be pushed 4 times in opening. Put Dip Switch no. 8 and
RX Ft1
1
9 on ON. On first command of PP button, the gate will close, now the programming
2
will start. Push button PP and motor M1 will start opening, after that push button PP
if you want to open motor M2. Push button PP when you would like to start programming
3
the slowing down of motor M1 and push it again to program slowing down of M2.
4
Wait until the motors stop. The slowing down times will be automatically programmed
5
also for closing procedures. Put Dip Switch 8 and 9 on OFF and proceed with clutch
programming.
GB
12