motormatic CT-2-24 Manual De Instrucciones página 28

CLUTCH PROGRAMMING
After the working time programming you need to make 2 complete manoeuvres (better
if more), in order to have the referring worth, which can be regulated with Trimmer T1.
-Put Dip Switch on ON and push button PP.
Wait until manoeuvre has been completed
-Push again button PP and wait again the complete manoeuvre.
-Push again button PP and wait again the complete manoeuvre.
-Push again button PP and wait again the complete manoeuvre.
-Push again button PP and wait again the complete manoeuvre.
-Put Dip Switch no. 9 on OFF.
Now you can use PP. It will start using pre-set parameters for the wing delay and
slowing down times.
INTERNAL RECEIVER PROGRAMMING
Only on central unit (900CT-2-24) you can program Rolling Code
transmitters (900TXP-42R, 900TXG-44R, TXB-42R). Memory can
contain up to 27 transmitters
-Position DIP 10 on ON. Memo Led will flash slowly.
-Transmit with transmitter you wish to memorize
-If Memo Led will make a long lightning, it means that programming has
been well done
-If the code has already been memorized, led will flash quickly
-Position DIP 10 on OFF.
If you need more transmitters, you need to use CT-2-24S with
receiver (900RXI-41/42 /R) and proceed with programming as
indicated on the receiver's instruction.
TRANSMITTER CANCELLATION
Wit Dip Switch no. 10 on ON you can press button PP and the memo led will pass
from a slowing flash to a faster one, which states that you can cancel the transmitter.
Press the transmitter you need to cancel and if procedure has been correctly done,
the memo led with light on for 2 seconds.
COMPLETE MEMORY RESET
To reset all radio and working parameters, put Dip Switch no. 8, 9, 10
on ON and press button PP. Put Dip Switch 8, 9, 10 on OFF.
Put Dip Switch no. 10 on OFF.
13
Conexión del Codificador
PS-300-24
Verde
PS-400-24
Blanco
Amarillo
INT-24
Blanco Verde
SN-50-24
Verde
Blanco
PS-200
-
M1 M2
1 2 3 4 5 6 7 8 9 10
DIP SWITCH
DIP SWITCH
1 FUNCIÓN INTERMITENTE/CORTESÍA
2 PAUSA EN APERTURA CÉLULA FOTOELÉCTRICA
3 FUNCIÓN EXCLUSIÓN DE CIERRE AUTOMÁTICO
4 FUNCIÓN NORMAL/CONDOMINIO
5 FUNCIÓN GOLPE DE ARIETE
6 FUNCIÓN TIEMPO DE PREAVISO INTERMITENTE
7 FUNCIÓN PASO/PASO CON PAUSA
8 PROGRAMACIÓN FASE DE TRABAJO ( véase Pág. 12 )
9 MODALIDAD AVANZADA MEMO. TIEMPOS DE TRABAJO ( véase pág.12)
10 MODALIDAD PROGRAMACIÓN RADIOMANDO ( véase Pág. 12 )
Verde
Negro
Amarillo
Verde Rojo
Verde Maron
+
M2 M1 M2
M1
4
E