Standard Accessories - HIKOKI DB 3DL2 Instrucciones De Manejo

Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2012/19/
EU on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
V Rated voltage
n
No-load speed
0
Ls Low speed
Hs High speed
Metal
Machine screw
Wood screw
Hex. drive size
Weight
(According to EPTA-Procedure 01/2014)
kg
Drilling
Switching ON
Switching OFF
Disconnect the battery
Change rotation speed - High speed
Change rotation speed - Low speed
Clockwise rotation
Counterclockwise rotation
Light switch
When adjusting the handle position, keep hands
and fi ngers away from this area.

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package contains the
accessories listed on page 124.
Standard accessories are subject to change without notice.
APPLICATIONS
○ Driving and removing of machine screws, wood screws,
tapping screws, etc.
○ Drilling of various metals
SPECIFICATIONS
The specifi cations of this machine are listed in the Table on
page 124.
NOTE
Due to HiKOKI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
CHARGING
Before using the power tool, charge the battery as follows.
1. Connect the charger's power cord to the receptacle.
2. Insert the battery into the charger. (Fig. 2)
Firmly insert the battery into the charger till it contacts the
bottom of the charger and checking the polarities.
Inserting the battery will turn on the charger (the pilot
lamp lights up).
CAUTION
○ If the pilot lamp does not light up, pull out the power
cord from the receptacle and check the battery
mounting condition.
○ If the battery is heated due to direct sunlight, etc.,
just after operation, the charger pilot lamp may not
light up. At that time, cool the battery fi rst, then start
charging.
● Regarding the temperatures and charging time of the
battery.
The temperatures and charging time will become as
shown in Table 1
Battery
Charging voltage
Weight
Type of battery
Temperatures at which the battery
can be recharged
Charging time for battery capacity,
approx.(At 20°C)
1.5 Ah
Number of battery cells
The pilot lamp goes off to indicate that the battery is fully
charged.
NOTE
The recharging time may vary according to the ambient
temperature and power source voltage.
3. Disconnect the charger's power cord from the
receptacle.
4. Hold the charger fi rmly and pull out the battery.
NOTE
Be sure to pull out the battery from the charger after use,
and then keep it.
CAUTION
If the battery charger does not work while the battery
is mounted correctly, it is probable that the battery or
charger is malfunctioning. Take it to your authorized
Service Center.
5
English
Table 1
Charger
UC3SFL
V 3.6
kg 0.3
EBM315 (Li-ion)
0°C – 50°C
min. 30
1