Publicidad
Idiomas disponibles
Idiomas disponibles
5. FITTING THE FOCUS BARS.-
Insert the focus bar spindle (24)
through the spacer bushes on the
main post (23), Fig.7, leaving it
centred.
Fit the spacer washers (20) as shown
in Fig.7. Insert the left focus bar (19L)
(marked with the letter "L") onto the
focus bar spindle (24), Fig.7, then fit
the right focus bar (19R) (marked with
the letter "R") on the other end of the
spindle. Fit the bolts (16) and the flat
washers (11,17) and with the help of
the box spanners tighten securely.
6. FITTING THE FEET.-
Take the right pedal (31), Fig.8,
(marked with the setter "R") and slide
it onto the crank shaft on the right-
hand side of the machine.
Now take washer (49) (50) and bolt
(16) and tighten securely.
Take the left pedal (31), Fig.8,
(marked with the setter "L") and slide it
onto the shaft on the left-hand side of
the machine.
Now take washer (49) (50) and bolt
(16) and tighten securely.
Attach the bottom covers (51), Fig.8,
and fit screws (50).
7. FITTING THE FOOT BARS.-
Take the right foot bar (31) and
position it on the "U" at the bottom of
the right focus bar (19R), Fig.9.
Insert screw (28), as shown in Fig.9,
then fit the flat washer (34) and the
self locking nut (35), and tighten
securely.
Take the left foot bar (19L) and go
through the same assembly procedure
as with the right.
8. FITTING THE UPPER
FOCUS BARS.-
Take the top left bar (13L) (marked
with the letter "L").
Insert the top bar onto the bottom left
focus bar (19L), lining up the letters
(L), Fig.10, fit the screws (10), the
washers (11)(12) and tighten securely.
Now go through the same procedure
for the top right focus bar (13R).
9. FITTING THE FOOTRESTS.-
Next, remove the screws (48), the flat
washers (11) (45) and the knobs (46)
and position the right footrest (25R)
(marked with the letter "R") on top of
the unit's right foot (31), Fig.11, (left
and right refers to the user's position
doing exercise) refit the knobs (46),
the washers (11) (45) and the screws
(48) removed previously and tighten
securely.
Next, position the left footrest (25L)
(marked with the letter "L") on top of
the left foot (31), refit the knobs (46),
the washers (11) (45) and the screws
(48) removed previously and tighten
securely.
10. FITTING THE HANDLEBAR.-
Take the handlebar (21), remove
screws (10) (11) (22), position the
ends of the handlebar on the plate at
the top of the main post (23), Fig.12.
Refit the screws
removed previously.
11. FITTING MONITOR.-
ATTACHING THE FEEDBACK CABLE
Take hold of the cable (3), which is
sticking up out of the main post (23),
and plug it into the connector of the
electronic unit (1), as shown in Fig.12.
15
(10)
(11)
(22)
Publicidad
