Publicidad
Idiomas disponibles
Idiomas disponibles
FITTING THE HAND-GRIP CABLE.
Take hold of the Hand-grip connectors
(9) (3), sticking out of the main post
(23),
and
plug
connectors located at the back of the
monitor (1), as shown in Fig.12.
ATTACHING THE MONITOR.-
Release screws (2), Fig.12, at the
back of the monitor.
Next, slide the front of the monitor
onto the plate on top of the main post
(23) in the direction of the arrow,
Fig.12, push the cables down into the
main post making sure not the pinch
any of the cables. Replace the screws
(2) removed previously.
ATTENTION:
It is important to retighten all of the
screws involved in assembling the
machine after approximately a week of
use as this will prevent any strange
noises and possible damage.
FITTING THE MONITOR COVER.
Take the covers (4B) (4F) and
position them on the main post (80),
Fig.12.
Now use the screws (5) to attach
them to the post.
MAINS CONNECTION.-
Insert the jack (m) on the transformer
them
into
the
(98) into the connection hole (k) on the
main body (43) (bottom, rear of the
machine)
transformer into a 220 V mains supply,
Fig.13.
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This
can be achieved by screwing the
adjustable feet (94) up or down, as
shown in Fig.13.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (74)
to make it easier to move. The wheels
located at the front of your unit make it
easier to move it into a chosen
position, by lifting the rear of the unit
up slightly and pushing it, as shown in
Fig.14. Store your unit in a dry place,
preferably not subject to changes in
temperature.
Do not hesitate to get touch with the
Technical Assistance Service if you
have any queries by phoning customer
services (see last page in manual)
BH RESERVES THE RIGHT TO
MODIFY THE SPECIFICATIONS OF
ITS PRODUCTS WITHOUT PRIOR
NOTICE
16
and
then
plug
the
Publicidad
