Publicidad
Idiomas disponibles
Idiomas disponibles
4. FITTING THE FOOT BARS.-
Take the left foot bar (50) and position
it on the "U" at the bottom of the left
focus bar (20), Fig.6.
Insert screw (151), as shown in Fig.6,
then fit the flat washer (154) and the
self locking nut (153), and tighten
securely. Take the right foot bar (61)
and go through the same assembly
procedure as with the left.
5. FITTING THE FOCUS BAR
SIDE COVERS TO THE FOOT
BARS.-
Take the covers (147 and 148),
marked on the inside with the letter
"R", and position them at the end of
the foot bars with the inside of the
focus bars on the right hand side, as
shown in Fig.6. Now use screws (152)
and (51) to attach them.
Carry out the same procedure using
the covers (147 and 148) marked on
the inside with the letter "L".
Next, release the screws (5 and 9) of
the main post (4), take bottle holder
(143), and insert it in through the top
of the post (4) in the direction of the
arrow.fig7. Attach the bottle holder
using screws (5 and 9) previously
removed. fig 7.
6. FITTING THE HANDLEBAR.-
Bring the handlebar (35) up to the
handlebar stem (4), Fig.7, insert the
hand-grip cable (49) in through the
slot as shown in Fig.7, and pull it out
through the top of the handlebar stem.
Insert screw (156), put the washer
(157), then fit the bracket cover (146).
7. FITTING THE ELECTRONIC
MONITOR.-
Release screws (41) at the back of the
monitor.
Next, slide the front of the monitor onto
the plate (2) in the direction of the
arrow, Fig.8, push the cables down into
the main post making sure not the
pinch any of the cables.
Replace the screws (41) removed
previously.
Bring the monitor (1) to the handlebar
stem (35) figure 8, connect the two
terminals coming out of the handlebar
stem (35) and the monitor (1), figure 8.
Insert
the
handlebar stem (4), as shown in Fig.8,
making sure not to pinch any of the
cables. Fit the bolts (3) along with the
flat washers, securely tighten.
LEVELLING.-
Once the unit has been placed into its
final position, make sure that it sits flat
on the floor and that it is level. This
can be achieved by screwing the
adjustable feet (86) up or down, as
shown in Fig.9.
MOVEMENT & STORAGE.-
The unit is equipped with wheels (83),
as shown in Fig.10, which make it
easier to move. The two wheels at the
front of the unit make it easier to place
the unit in to any chosen position by
lifting the rear slightly.
Store your unit in a dry place,
preferably not subject to changes in
temperature.
15
monitor
(1)
onto
the
Publicidad
