Securing Your Child; Infant Car Seat Mode; Using The Infant Car Seat Receivers - Britax PATHWAY Guia Del Usuario

Securing Your Child

1� Release the harness by depressing the
button in the center of the buckle while
pulling the two tongues away from the
buckle assembly�
2� Fasten the harness by inserting the
tongues on the harness straps into the
buckle assembly�
3� Tighten or loosen the harness straps by
sliding the harness adjusters�
12

Infant Car Seat Mode

• All infant car seats MUST be installed rear facing�
• Always remove the infant car seat receivers when not in use�
Failure to do so may result in injury�
IMPORTANT: For non-Britax infant car seats, an infant car seat
adapter frame must be used� This adapter frame is sold separately at
select retailers and on us.britax.com�

Using the Infant Car Seat Receivers

Attaching the Infant Car Seat Receivers
NOTE: Receivers are marked left and right. Attach each from the
position of the occupant.
1� Lock the parking brake�
2� Unsnap the stroller seat straps from
the frame of the stroller�
3� Align the receivers with the mounts on
the inside frame of the stroller, then
push down until a click is heard� Pull
up on the receivers to ensure they are
secure�
CLICK
13