Unpacking; Packing List; Assembly - Husky HU80833 Manual Del Operador

UNPACKiNg

This product requires assembly.
 Carefully cut the box down the sides then remove the
product and any accessories from the box. Make sure
that all items listed in the packing list are included.
NOTE: This product is heavy. To avoid back injury, lift with
your legs, not your back, and get help when needed.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-866-340-3912 for assistance.
wARNiNg:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.

PACKiNg LiST

Pressure Washer
Trigger Handle
25 ft. High Pressure Hose
Self-Coiling Garden Hose
Spray Wand
Quick-Connect Nozzle (3)
Soap Blaster™ Nozzle
Nozzle Holder with Spring Clip
Nozzle Cleaning Tool
Injection Hose and Filter
Top Trigger Handle Holder
Bottom Trigger Handle Holder
Trigger Handle Holder Screws (4)
Trigger Handle Holder Nuts (4)
Handle Bar
Cleaning deck
4-Cycle Engine Lubricant (SAE 10W30)
Operator's Manual
wARNiNg:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Failure to heed this
warning could result in serious personal injury.

ASSEMBLY

wARNiNg:
Do not attempt to modify this product or create acces-
sories not recommended for use with this product. Any
such alteration or modification is misuse and could result
in a hazardous condition leading to possible serious
personal injury.
wARNiNg:
To prevent accidental starting that could cause serious
personal injury, always disconnect the engine spark plug
wire from the spark plug when assembling parts.
iNSTALLiNg ThE hANDLE BAR
See Figures 2 - 3.
 Remove the acorn nuts and handle knobs from frame.
 Retract handle bolts until end of bolts are flush with handle
spacers.
 Install handle bar as shown. Handle bar should rest in
grooves of spacers and holes in handle bar should align
with handle bolts.
 Press handle bolts through openings in handle bar.
 Re-thread knobs on handle bolts and tighten to secure.
 Re-thread acorn nuts on end of handle bolts and tighten
with wrench (not provided).
 Place spray wand into storage clips located on the side
of handle bar.
iNSTALLiNg TRiggER hANDLE hOLDERS
See Figures 4 - 5.
 Place top trigger handle holder over handle bar and align
holes.
 Secure using screws and nuts as shown.
 While holding screw with Phillips screwdriver, tighten each
nut with wrench to secure.
 Repeat process to install bottom trigger handle holder.
 Clip flat area of trigger handle into top holder and bottom
ribbed area of trigger handle into bottom holder. Slide
forward until trigger handle rests securely in holders.
 Rotate trigger handle so that bottom edge of handle snaps
into handle lock.
ASSEMBLiNg ThE SPRAY wAND
See Figure 6.
 Insert the end of the spray wand into the trigger handle
outlet coupler as shown in figure 6 and push together
until coupler snaps into place.
7 — English