Range Selection; Unpacking And Inspection; Operation - Wavetek Meterman DM2 Manual De Instrucciones

VC12
RTL25
Upon removing your new digital multimeter (DM2) from its packag-
ing, you should have the following items:
1. DM2 Digital Multimeter
2. Test Lead Set (1 black, 1 red)
3. 9 Volt Battery (in meter)
4. Warranty Card
5. Operator's Manual
6. One Spare Fuse (0.8A/250V)
If any of the above items are missing or are received in a damaged
condition, please contact the distributor from whom you purchased
the unit.
Familiarization (Fig.1)
1. Function/Range Switch: Selects the Function and Range desired.
2. COM Input Terminal: Ground input connector. 500V (DC + AC
Peak) Maximum voltage between COM and earth ground.
V Ω Input Terminal: Positive input connector for voltage, resistance,
3.
and diode test. Maximum input rating is 1000VDC, 500VAC.
4. 200mA Input Terminal: Positive input connector for up to 200mA
current. Fused.
5. Lo Bat: Indicates batter is low.

Range Selection

If magnitude to be measured is unknown, always start with the high-
est range.
PRECAUTION!
Overload Condition: Range overload is indicated by a "1." Or by a "-
1." In the display with all other digits blanked. This is normal in the
ohms range when the leads are not connected to anything. In all other
situations, the user must take immediate steps to remove the cause of
ACCESSORIES
Vinyl Carring Case
Replacement Test Leads

UNPACKING AND INSPECTION

OPERATING INSTRUCTIONS
– 3 –