Installation - Dometic RH430STE Instrucciones De Montaje

Installation

6 Installation
The cooling device is designed for free-standing installation, but can be built-
in if the following conditions are complied with to ensure satisfactory opera-
tion and maximum cooling efficiency.
 The cooling device must be levelled carefully to ensure proper function.
 The clearance between the cooling device's back and the wall should be
20 mm or more.
 Ventilation must be provided as shown in alternatives A, B, C or D (fig. 2,
page 3).
 The ventilation duct must at least measure 105 mm* x the width of the
cooling device.
 Only the entire cooling unit must project into the ventilation duct as shown
(fig. 2, page 3).
 Air passing through the ventilation duct must not be preheated by any
source of heat.
 Ventilation grills, if used, must have openings of at least 200 cm² each.
 For glass door version, when ambient humidity is above 65 % in 25 °C
ambient temperature, moisture will condense on the door.
 The cooling device can be fixed to the bottom of the furniture through its
fixing feets using screws of an appropiate length (fig. 3, page 3).
 The socket outlet for the mains connection must be freely accessible.
8
RH430, RH440
EN