Safety instructions
CAUTION!
!
Disconnect the device from the power supply
– before each cleaning and maintenance
– after every use
Food may only be stored in its original packaging or in suitable
containers.
NOTICE!
A
Check that the voltage specification on the type plate
corresponds to that of the energy supply.
Connect the device with the 230 V connection cable to the
230 V AC mains supply.
Never pull the plug out of the socket by the cable.
The cooling device is not suitable for transporting caustic
materials or materials containing solvents.
The cooling device contains inflammable cyclopentane in the
insulation. The gases in the insulation material require special
disposal procedures. Deliver the device at the end of its life-
cycle to an appropriate recycling.
2.2
Operating the device safely
CAUTION!
!
Before starting the device, ensure that the power supply line
and the plug are dry.
NOTICE!
A
Do not use electrical devices inside the cooler unless they are
recommended by the manufacturer for the purpose.
Do not place the device near naked flames or other heat
sources (heaters, direct sunlight, gas ovens etc.).
Danger of overheating!
Ensure at all times that there is sufficient ventilation so that the
heat that arises during operation does not build up. Make sure
that the device is sufficiently far away from walls and other
objects so that the air can circulate.
Ensure that the ventilation openings are not covered.
Do not fill the inner container with ice or fluid.
Never immerse the device in water.
6
RH430, RH440
EN