Cleaning And Maintenance - Teka CMB1 Manual De Instrucciones

Instructions for use
You can activate or deactivate the cooker
hood by operating the functions shown in
the diagram.
Switch on the extractor fan a few minutes
before you start to cook in order to ensure
that a steady air flow has been established
before fumes appear.
Allow the extractor fan to run for several
minutes after you have finished cooking in
order to expel all the grease from the outlet
duct. This prevents the return of grease,
smoke and smells.
Light
Minimum speed
Medium speed
Maximum speed
Pilot indicator

Cleaning and maintenance

During cleaning and maintenance work, make
sure the safety instructions are complied
with.
Cleaning the hood body
•If your kitchen hood is made of stainless steel,
use proprietary cleaners mentioned in the
product instructions.
•If your kitchen hood is painted, use lukewarm
water and a neutral soap.
•Never use metallic scourers, nor abrasive or
corrosive products.
•Dry the kitchen hood using a cloth that does not
produce fibres.
•Do not use vapour cleaners.
Cleaning the metal filters
•To remove the filters from their fittings, press
lightly on the locks and then pull them off.
•The metal filters can be cleaned by soaking
them in hot water with neutral detergent until
the fat dissolves and then rinsing them under
the tap or using special anti-grease products.
They can also be washed in a dishwasher. In
this case, it is advisable to stack them vertically
to avoid food residues to stick to them.
•Cleaning in a dishwasher may damage the
metallic surface (blackening it), although this will
not affect its fat retention capacity.
•Once clean, leave them to dry off and then fit
them onto the kitchen hood.
Lamps
Proceed as follows:
•Remove the metal filters.
•Change the broken/burnt out lamp.
•Fit the metal filters.