Tabla de contenido
Publicidad
1
o
2 or 6: Add horizontal or vertical weed cuts inside the shapes (this is used for applications such as
glass etching where the outside "waste vinyl" is actually kept and the shapes themselves are
weeded out)
2
o
3 or 7: Add horizontal or vertical weed cuts in between shapes and outer weed border and also
inside and between shapes
3
o
4 or 8: Add horizontal or vertical weed cuts anywhere you like
4
Reset: At any point, you can click on Reset to remove any of the internal cut lines and begin again.
•
Once you are satisfied with the weeding line, click on OK:
•
On the Layers Panel you will observe a new layer called Weeding:
5
6
7
8
223
Publicidad
Tabla de contenido
