Tabla de contenido
Publicidad
Cut Settings:
Choose either
WYSIWYG or
Origin Point (refer
to Section 10.07)
PRO version: enter where
head should go at end of cut
o
Cut Mode: Refer to Section 10.07 which covers controlling where shapes will cut.
o
End Action (PRO version only): controls what happens at the conclusion of the cut. There are three
choices:
▪
Rewind to origin: default setting in which the head returns to the origin set before the cut
began
▪
Advance Amount: when this option is selected, the head moves to the end of the cut, over to
the right side, and then advances the mat or rolled material forward based on a value you enter
into a new window:
Select Advance Amount
and a new input pops up
▪
Do Nothing: the head stops at the location where it finished cutting
o
Cut selection only: If you have pre-selected which shapes you want to cut, then mark this box.
o
Mirror H and Mirror V: Options to check if you want the shapes mirrored for cutting. This is very
handy when cutting HTV or embossing. In both cases, you will be flipping over the material once the
cutting or embossing is complete.
Cutting/Drawing Settings: As mentioned earlier, this section will vary considerably from one
brand/model of cutter to the next:
Select a Preset of
suggested settings
Select type of tool
Change settings,
as needed
o
First, select the Tool (left or right side) and then, if you like, select from the Preset menu, the
material you will be cutting. Alternatively, make any changes to the settings for this material. If you
wish to save the new settings, click on the icon
will open:
Select Tool (1 or 2)
to the right of Preset and the following window
Check if only selected
shapes should be cut
Check either or both if you
wish to have shapes mirrored
before cutting (on the KNK
Force, these are reversed)
Enter distance to advance
Click here to change out a
tool on the KNK Force
Add a new Preset
Add a new tool
Select type of action
228
Publicidad
Tabla de contenido
