KNK Force SCAL Manual De Usuario página 238

Check this box first to
then activate other
settings
Mark this option to
use Cutting Mat
dimensions or enter
actual size of
material
Mark Autofit or enter
desired numbers of
Columns and Rows

Cut Copies: Mark this option first so that other settings become editable

Match workspace dimensions: If your material is the same size as the Cutting Mat, then mark this
option. Otherwise, enter the Width and Length of the material to be used. Pay attention to the Preview
window to make sure you have the orientation correct to match how the material is placed on the cutting
mat.

Auto fit columns and rows: Mark this option if you want as many duplicates as possible cut from the
material. Otherwise, enter the desired number of Columns and Rows to match the number of copies
needed.

Spacing: Adjust the spacing as desired. In general, shapes can be quite close together when cutting
from thinner materials, such as vinyl and cardstock. In some cases, such as with a star, you can even
use 0 for the Row Spacing, since the bottom of the shape is not close to the top of the shape in the row
below it:
•
Make sure you have all of the cut settings made under the General tab of the Cut Settings window. Once
you click on Cut, all of the duplicates will be cut out and it appears that using Cancel, in the current version
of SCAL, will not abort the cut.
Select Extras tab
Enter desired Spacing for
both Columns and Rows
Row Spacing: 0
The Preview will update
as settings are changed
Plenty of room between the rows
238