Rupes SSPF Instrucciones De Uso Y Manutención página 9

SAFETY WARNINGS APPLICABLE TO POLISHING OPERATIONS
If the use of an electrical tool in a damp area cannot be avoided,
use a power supply fitted with a differential switch (RCD).
This type of switch reduces the risk of electrical shocks.
PARTS OF THE TOOL
1 - Identification plate
2 - ON/OFF switch
3 - Handle
4 - Auxiliary handle
5 - Auxiliary handle fixing screw
6 - Drilled rubber velcroed plate, rubber drilled plate, standard rubber
plate (depending on the model)
7 - Paper clamping lever
8 - Abrasive paper punching device (optional)
9 - Filter support grid (SSPF - SSCA)
10 - Dust filter (SSPF - SSCA)
11 - Motor ventilation slots
12 - 29 mm Ø suction port
13 - Plate-suction turbine connecting pipe (SSCA)
14 - Dust bag (SSCA - SO31TE)
15 - Speed control (SO31TE)
STARTING UP
Before starting-up the tool, ensure that:
- the packaging is complete and does not show signs of having been
damaged during storage or transport;
- the tool is complete; check that the number and type of
components comply with that reported in this instruction booklet;
- the power supply and socket outlet can support the load reported in
the table and that indicated on the tool identification plate
reproduced and explained on page 11.
ASSEMBLING THE TOOL
Fit the auxiliary handle (4) to the tool using the screw supplied (5);
SSPF:
Place the protective filter (10) in its box (9) and push fit the complete
unit on the body of the tool.
SSCA:
Assemble the plate-turbine connecting pipe (13) which has a push fit;
mount the dust collecting bag (14).
INSERTING THE ABRASIVE PAPER
SSPF - SSCA DRILLED RUBBER PLATE VERSION
- Repeat this operation
- punch the paper using the tool supplied (8).
SSPF - SO31TE VELCROED DRILLED RUBBER PLATE VERSION
- Press che velcro backed paper in position, ensuring that the holes
in the paper coincide with the suction holes in the plate;
- Lift-up the paperclip (7) pushing the flaps and place the abrasive
paper (SO31TE)
BEFORE STARTING THE TOOL
Ensure that:
- the power supply conforms with the characteristics of the tool;
- the power supply cable and plug are in perfect condition;
- the ON/OFF switch works properly though with the power supply
disconnected;
- all the parts of the tool have been assembled in the proper manner
and that there are no signs of damage;
- the ventilation slots are not obstructed (11);
- the tool must be connected to a suitable and efficient dust
extraction system.
STARTING AND STOPPING
- Starting: push the slide of the ON/OFF switch (2) forward.
- Stopping: return the switch (2) to its original position.
TEST RUN
Start the tool and check that there are no unusual vibration and that
the paper is kept out. Otherwise switch-off the tool Immediately
and eliminate the cause.
REPLACING ABRASIVE PAPER
SSPF - SSCA DRILLED RUBBER PLATE VERSION
- Lift the paper clamping lever (7) by pressing the release device and
remove the used paper;
- insert the new abrasive paper following the instructions in the
chapter on "INSERTING THE ABRASIVE PAPER".
9