Airwell DED076 Manual De Usuario página 13

3.1.4 Installation
Fig. 3.7 is the simple installation process of wired controller; please pay attention to the
following items:
(1) Before installation, please cut off the power for indoor unit.
(2) Pull out the two-core twisted pair from the installation hole on wall, and then pull this
wire through the " " shape hole at the rear side of Soleplate of wired controller.
(3)Stick the bottom plate of wired controller on the wall and then use Self-tapping Screw
ST3.9X25 MA to fix Soleplate and installation hole on wall together.
(4) Connect two-core twisted pair to H1 and H2 wiring column and then fix the screws.
(5) Set two-core into the groove at left side of wiring column, and then bundle panel and
Soleplate of wired controller together.
Note: If the wire size of the selected communication line is too large, you can peel some
sheath layer of communication wire to satisfy installation requirements.
Fig. 3.7 Installation diagram for wired controller
10
User Manual Wired Controller