Parameter Setting - Airwell DED076 Manual De Usuario

User Manual Wired Controller
View the air
outlet
C20 temperature of
Fresh Air
Indoor Unit*
Note:
① Under parameter viewing status, FAN, TIMER, SLEEP and SWING buttons are
invalid. Press "ON/OFF" button to go back to the home page, while not to turn
on/off the unit.
② Under parameter viewing status, the signal from remote controller is invalid.

3.2.3 Parameter Setting

Unit parameters can be set in unit On or Off status.
(1) Long press FUNCTION button for 5s and the temperature zone displays "C00"; long
press FUNCTION button for another 5s to enter the interface of setting wired
controller parameters. "P00" is displayed in temperature zone;
(2) Press " " or " " or "
parameter setting. At that time, parameter value is blinking. Press "
button to adjust the parameter value and press ENTER/CANCEL button to finish
setting.
(3) Press ENTER/CANCEL button to return to last step until exists setting parameters.
The parameter setting list is as following:
--
" butt " button to select parameter code. Press MODE button to enter
function.
3) After the one-button viewing function
is turned on, pressing the "ON/OFF"
button of any wired controller of the
same system network under on/off
status will cancel this function.
Operation method:
Enter viewing, short-press "MODE"
button in "C20" status to enter the
interface of viewing air outlet
temperature of Fresh Air Indoor Unit.
Press " " or " " or "
indoor unit.
Display method:
Temperature zone: displays current
indoor unit project number
Timer zone: displays air outlet
temperature of Fresh Air Indoor Unit
Note: only applicable to Fresh Air
Indoor Unit.
15
" button to select t " button to select the
" or " "