Preparing Machine For Restorative Extraction Cleaning - Nobles ReadySpace Strive 9000503 Manual Del Operador

PREPARING MACHINE FOR RESTORATIVE EXTRACTION CLEANING

FOR SAFETY: Before preparing machine,
turn machine off and remove key.
Step 1:
Unlatch the idler plates and remove
the two ReadySpace rollers if installed.
Step 2:
Disconnect the
vacuum hose and
the vacuum tube
from the rear
ReadySpace
vacuum shoe if
installed.
READYSPACE
VACUUM SHOE
(2) 6mm SOCKET
HEAD CAP SCREWS
Step 3:
Disconnect the solution flush lines from the
rear vacuum shoe (See DETAIL A).
Step 4:
Remove the ReadySpace vacuum shoe.
6 mm hex head tool required.
Step 5:
Install the two extractor
brushes (See DETAIL B).
IDLER
PLATE
(2) 6mm SOCKET
HEAD CAP SCREWS
Step 6:
Install the extractor vacuum
shoe. Use the screws removed from
Step 4. Connect the vacuum hose to
the extractor vacuum shoe as shown.
Nobles Strivet (11- -04)
Equipment Needed:
1) Two Extractor Brushes
2) Extractor Vacuum Shoe
3)
VACUUM
TUBE
EXTRACTOR
SHOE
Home Find... Go To..
3
6 mm Hex Head Tool
(supplied with machine)
SCRUB HEAD
SOLUTION
FLUSH LINE
NOTE: To prevent misplacing,
DO NOT remove the disabled
solution flush lines and the
vacuum tube from the scrub head.
TOP VIEW
The brushes V--pattern
(chevron) should point
towards each other.
OPERATION
1
2
DETAIL A
Push the retainer tab up-
ward to disengage the
solution flush line tip.
DETAIL B
NOTE:
"I" indicates idler plate end.
11