While Operating Machine - Nobles ReadySpace Strive 9000503 Manual Del Operador

2. To begin cleaning, rotate the control grips forward
and gradually turn the speed control knob to the
recommended cleaning speed of 30m (100 ft.) per
minute for ReadySpace and 15m (50 ft.) per
minute for Restorative Extraction (Figure 7).
NOTE: The machine's maximum cleaning speed is set
at 36m (120 ft.) per minute for ReadySpace and 15m
(100 ft.) for Restorative Extraction.
To operate the machine in reverse, simply rotate
the control grips backwards. The machine will
continue to clean in reverse during ReadySpace
cleaning. This allows you to back clean over
heavily soiled areas, into corners and tight spaces.
When reversing during restorative extraction the
scrub head will raise and cleaning stops.
FIG. 7
3. Adjust the brush pressure meter within the green
zone by pressing the brush pressure switch. For
best cleaning results, adjust the brush pressure
meter as shown below (Figure 8).
ATTENTION: Do not operate the machine with the
brush pressure meter in the red zone, circuit
breakers will trip.
For Restorative
Extraction
FIG. 8
4. To stop the machine, position the machine on a
level surface and gradually release the control
grips.
5. After restorative extraction cleaning, place air
movers in the area to reduce the drying time.
6. Perform the DAILY MACHINE MAINTENANCE
procedures.
Nobles Strivet (09- -04)
For ReadySpace
Home Find... Go To..

WHILE OPERATING MACHINE

WARNING: Fire Or Explosion Hazard. Do Not
Pick Up Flammable Materials Or Reactive Metals.
1. Overlap each cleaning path by 50 mm (2 in).
2. Use a collapsing rectangle pattern when cleaning
large rooms (Figure 9).
FIG. 9
3. If excessive foam appears in the recovery tank,
pour a recommended foam control solution into
the tank.
ATTENTION: Do not allow foam to enter the float
shut-off screen, vacuum motor damage will result.
Foam will not activate the float shut-off screen.
4. Do not operate machine on inclines that exceed 3°
when cleaning or 11° while transporting.
FOR SAFETY: When using machine, go slow on
inclines and slippery surfaces.
5. Observe the battery meter discharge level
(Figure 10). When the meter begins to flash, stop
scrubbing and transport the machine to the
recharging area. When two lights begin to flash
alternately, the scrub head will automatically raise
to the transport position. This will protect the
batteries from total discharge. Recharge batteries
immediately.
FIG. 10
6. Observe the solution tank sight gauge for
remaining solution.
7. When leaving the machine unattended, park the
machine on a level surface and remove the key.
OPERATION
13