GE GTH21 Manual De Uso página 25

Installation instructions
NI REHANG THE REFRIGERATOR
DOOR
Lower the refligerator door onto the bottom
hinge pin°
Plastic
Screw die b,,vo screws into die center hinge location
on die left side with a 5/16" socket and ratchet.
Smdghten file door and place the center hinge pin
into the opening on top of file door Remember to
include tlle washer
Move the door into place, so you can align tlle center
hinge bracket over tlle center hinge holes on die left
side. Insert and tighten the two screws with a 5/16"
socket and ratchet.
NOTE: Ensure die washer is in place on top of die
hinge pin.
I ..............
PlasticWasher_b
Hinge
CenterHinge
Bracket
Refrigerator D oor
[] REHANG THE FREEZER DOOR
Lower die fleezer door onto die center hinge pin.
Be sure die washer is in place.
igePin
Washer
iJfl die
top
hinge so die pin fits into die door socket.
Support the door on the handle side and make sme
the door is straight and the gap bet_,veen the doo_s is
even across the flont. While holding the door in
place, dghmn the top hinge screws.
[TO-] ADJUSTTHE DOORS
(IF NEEDED)
If the freezer door is too high:
Remove the hinge
cover on top of the
fleezer door and
loosen the four
screws with a 5/16"
socket and ratchet.
Replace tlle hinge
covei:
%
Loosen screws. 5/16" __
I
If both doors are too high:
1. Remove
the hinge
Loosen screws.
cover on
top of tlle
fleezer _
door and
loosen the
f}om screws
with a
5/16"
socket and
ratchet.
.
%
5/16
5/16"
_ oosen
screwsand
slideleft to
lowerdoors.
Loosen die two center hinge screws wkh a 5/16"
socket and ratchet.
3. Slide tlle center hinge to die left to lower
tlle doors.
4. Fully tighten all screws and replace top hinge cove,:
If both doors are too low:
1. Remove die
hinge cover
on top of
the fleezer
door and
loosen the t
fbur screws
with a 5/16"
socket and t
ratchet.
2. Loosen the
bwo cenmr
hinge screws
3.
Loosen screws. 5/16 '_'
5/16"
<&
Loosen
screws and
sliderightto
raisedoors.
wkh a a/16 socket and ratchet.
Slide tlle center hinge to die fight to raise
the doors.
4. Fully dghten all screws and replace
top hinge cove_:
NOTE: Save the door spacer
Doo_ may settle with use. Door Spacer
25