Installation Instructions - GE GTH21 Manual De Uso

Installation instructions
ICENIAKER iNSTALLATiON
BEFORE YOU BEGIN
Read each step thoroughly before proceeding.
CAUTION - U,,pl.:the
Refligerator To eliminate the danger
of electric shock during installation,
you must unplug the refligerator flom
its electrical outlet.
TOOLS YOU WILL NEED
Flatblade andPhillips Pliers
screwdrivers
PARTS INCLUDED
2
©
3
NO. DESCRIPTION QUANTITY
1 Water Fill Tube 1
2 IceFill Guide 1
3 Water Fill TubeSeal 1
m INSTALL FILL TUBE
• If the refligerator aheady has a
water tube inlet on the back of the
refiigerator, go to Step 2.
• Remove and discard the white plug
flom the lower left back corner of
the fleezer wall.
* Go to the back of the refligerator. Find the small
label in the upper right band corner and peel it
off_ Then discard the label.
Peel one side of the paper away _ Seat
flom the water fill tube seal, slide Ir'___
the seal along the tube and affix u -_-o4_._,'X,x
to the back side of the water
robe inlet flange.
Remove the adhesive
bacMng on the opposite side
of the water fill robe sea/and
slide the robe into the hole _
near the top at the back of the refiigeratcn: Fhmly
press on the inlet to secure it to the refligerator
iNSTRUCTIONS
_] REMOVE THE OUTLET COVER
• Remove the outlet cover
with a fiat-blade screwdriver
Side Back
_PREPARE FOR INSTALLATION
Inside the fleezeL loosen the h, v o mounting screws,
but do not screw them all the way out. If your model
does not have the screws aheady in the fieezer wall,
look for t_,vo plug buttons. Remove the plug buttons
and insert the two Phillips head screws. The screws
should extend approximately 1/2" (13ram) out
flom the fleezer wall
Mounting
screws
[-4-]SET POWER SWITCH TO 0 (off)
Set the icemaker power
switch to O (of_). Leave
the power switch in the O (offc) position undl the
refiigerator is connected to the water supply to
prevent premature operation.
_ Holef?r
wire tie
SwitchP°wer
...... _ _ + ........... - -%
(Appearance may vary)
13