Changing The Rotor Blades - Carrera RC RC Video Next Instrucciones De Montaje Y De Servicio

the quadrocopter rotates to the right, press the
trimmer for rotation in steps to the left.

Changing the rotor blades

Use a scredriver for unscrewing a rotor blade.
Make sure that you draw the rotor blade with
great care vertically upwards, and hold the
motor from below to stabilise it. Screw the ro-
tor blade firmly back on to the quadrocopter.
QR code for motor-change system, spare
parts and further information.
WARNING!
Be sure to note the marking and colour, also
the tilt angle of the rotor blades!
Front left: red – marking "A"
Front right: red – marking "B"
Rear right: black – marking "A"
Rear left: black – marking "B"
Troubleshooting
Problem:Remote control does not work.
Cause: The ON/OFF-power switch is turned
"OFF".
Solution: Turn the ON/OFF-power switch "ON".
Cause: The batteries have been wrongly insert-
ed.
Solution:Check if the batteries have been cor-
rectly inserted.
Cause: The batteries do not have enough power.
Solution:Insert new batteries.
Problem:The Quadrocopter cannot be controlled
with the remote control
Cause: The power switch on the reomote con-
trol is turned "OFF".
Solution:First turn the power switch on the re-
mote control "ON".
Cause: The remote control is possibly not cor-
rectly frequency bound with the receiver on the
Quadrocopter.
Solution:Please carry out the binding procedure
as described in "Checklist for flight preparation".
Problem:The Quadrocopter does not start.
Cause: The ‚Start rotors' button has not been
pressed on the controller.
Solution:Press the ‚Start rotors' button on the
controller.
Problem:The Quadrocopter does not lift.
Cause: The rotor blades rotate too slowly.
Solution:Slide the gas lever up.
Cause: The battery´s power is not sufficient.
Solution:Charge the battery (see chapter
"Charging the battery").
Problem:During flight, the Quadrocopter loses
speed and height without any obvious reason.
Cause: The battery is too weak.
Solution:Charge the battery (see chapter
"Charging the battery").
Problem:The quadrocopter only flies in a circle
or turns over on starting.
Cause: Rotor blades incorrectly fitted or dam-
aged.
Solution:Fit rotor blades / replace rotor blades as
described in
27 28 29
Problem:Wifi/W-Lan connection not possible.
Cause: The model's power switch is set to "OFF".
Solution:First switch the model's power switch to
"ON".
Errors and changes excepted
Colours / final design – changes excepted
Technical changes and design-related changes excepted
Pictograms = symbolic photos
22
.