Changing The Rotor Blades - Carrera RC 370503018 Instrucciones De Montaje

Auto-Start & Fly to 1.5m
22 Press the 'Auto-start & fly to 1.5 m' button on
the controller, in order to start the motors and
automatically fly up to the altitude of about
1.5 m . You are able to influence the direction
of flight at any time during the starting oper-
ation by means of moving the right joystick.
The Quadrocopter will maintain itself in posi-
tion automatically as soon as the altitude of
about 1.5 m has been reached.
Trimming the Quadrocopter
23 Auto-trimming
1. Place the Quadrocopter on a hori-
zontal surface.
2. Link the Quadrocopter with the con-
troller as described in "Linking the
model with the controller".
3. Slide the gas lever and the lever for
forward / back simultaneously into
the right lower corner. The LED on the
Quadrocopter flashes on briefly and
then lights up continuously. The signal-
ling tone will sound once.
4. The neutral setting is completed.
24 When hovering, if the Quadrocopter flies
to the left or right without you moving the
lever for left / right movement, please pro-
ceed as follows: If the Quadrocopter
moves on its own fast or slow sideways to
the left, press the lower right trimmer for
right / left tilt in steps to the right. If the
Quadrocopter moves right, press the trim-
mer for right / left tilt in steps to the left.
25 When hovering, if the Quadrocopter flies for-
wards or backwards without you moving the
lever for forwards or backwards movement,
please proceed as follows: If the Quadrocop-
ter moves on its own fast or slow forwards,
press the upper right trimmer for forwards /
backwards in steps downwards. If the Quad-
rocopter moves backwards, press the trimmer
for forwards / backwards in steps upwards.
ENGLISH
26
When hovering and without you moving the
lever for circling on the spot, if the quadrocop-
ter rotates to left or right, proceed as follows:
If the quadrocopter rotates quickly or slowly
to the left around its own axis, press the trim-
mer for rotation below left in steps to the right.
If the quadrocopter rotates to the right, press
the trimmer for rotation in steps to the left.

Changing the rotor blades

27 Use a scredriver for unscrewing a rotor
blade. Make sure that you draw the rotor
blade with great care vertically upwards,
and hold the motor from below to stabilise
it. Screw the rotor blade firmly back on to
the quadrocopter.
28 QR code for motor-change system,
spare parts and further information.
29 WARNING!
Be sure to note the marking and colour,
also the tilt angle of the rotor blades!
Front left: red – marking "A"
Front right: red – marking "B"
Rear right: black – marking "A"
Rear left: black – marking "B"
Troubleshooting
Problem: Remote control does not work.
Cause: The ON/OFF-power switch is
turned "OFF".
Solution: Turn the ON/OFF-power switch "ON".
Cause: The batteries have been wrongly
inserted.
Solution: Check if the batteries have been
correctly inserted.
Cause: The batteries do not have enough
power.
Solution: Insert new batteries.
Problem: The Quadrocopter cannot be con-
trolled with the remote control
Cause: The power switch on the reomote
control is turned "OFF".
Solution: First turn the power switch on the
24