Tuning In Dab (Digital Audio Broadcasting) Broadcasts; Preset Stations - Pioneer F-F6-J Manual De Instrucciones

05 Listening to DAB broadcasts
Tuning in DAB (Digital Audio
Broadcasting) broadcasts
POWER
STANDBY
OFF ON
Press the POWER or  button to turn on
1
the power.
2 Watching the display, press the BAND
button to select the desired band (DAB).
3 Watching the display, press the AUTO
TUNE or A.PRESET/A.TUNE button to start
automatically scanning.
Using the DAB for the first time
When you first switch on the unit and select
DAB, the Auto Tuning function scans the Band
III and L-band frequencies. After the scanning,
the first scanned component will be selected.
• Press the button and release it in less than
two seconds to perform a local scan (UK
band III). (UK stations are in the range 11B to
12D) (page 31).
• Press the button for over two seconds to
perform the full scan operation (Full band III
and L-band: 5A to LW) (page 31).
Note
1 Normal service components are displayed inside single angle brackets < >; secondary service components are displayed in
double angle brackets << >>.
20
En
BAND
SECONDARY RDS TUNED STEREO
DISPLAY
DIMMER
DISP
1 2 3
A/B/C
4 5 6
D/E/F
7 8 9
G/H
MEMORY A.PRESET/A.TUNE
10
I/J
TUNE+
MENU
ST- ST+
ENTER
TUNE-
BAND
MPX
• Once auto scanning is completed, the
number of broadcast stations is displayed,
then the first station is tuned in.
If "Station not available" is displayed,
check the antenna's connection (page 7).
F6
TUNING/PRESET
MENU
4 Either turn the TUNING/PRESET dial or
AUTO TUNE
press the ST + or ST – button to select the
station.
If the station you select is in stereo, the
STEREO indicator will light up.
Secondary services
When receiving a Secondary service, the
SECONDARY indicator lights blue.
When either the TUNING/PRESET dial or
ENTER button is pressed, the Secondary
service Component is received and the
SECONDARY indicator lights red.
Press TUNING/PRESET dial or ENTER button
to go back to the primary service again.
5 Press the TUNING/PRESET dial or press
the ENTER button to listen to the selected
station.
After "Now tuning..." is displayed, the tuned
in station appears.

Preset stations

1 Follow steps 1 to 4 under "Tuning in DAB
(Digital Audio Broadcasting) broadcasts"
(page 20) to tune in the station to be preset.
2 Perform steps 2 to 7 under "Preset
stations" (page 16).
• Up to 100 "S.Component" can be preset
(DAB alone).
1