Installation; Power Supply; Operation Using The External Dc Charger; Operation Using The Battery - Promax TV Explorer HD Manual De Usuario

USER'S MANUAL. TV EXPLORER HD / HD

3 INSTALLATION

3.1

Power Supply

The TV EXPLORER
Li-Ion battery. There is also an external DC charger provided for mains connection and
battery charging.

3.1.1 Operation using the External DC Charger

Connect the
TV EXPLORER HD /
press the rotary selector
operation and the battery is slowly charged. When the instrument is connected to the
mains, the CHARGER indicator [4] remains lit. This indicator changes of colour
according to the battery charge status:
RED
ORANGE
GREEN
Table 1.- Indication of the battery charge status (CHARGER).

3.1.2 Operation using the Battery

For the device to operate on the battery, disconnect the power cable and press the
rotary selector [1] for more than two seconds. The fully charged battery can power the
equipment for more than 4.5 hours non-stop.
If battery is very weak, the battery cut-off circuit will prevent the device from
functioning. In such a situation battery must be recharged immediately.
Before taking any measurements, you have to check the charge status of the
battery by checking the battery charge level indicator that appears when activating the
measurement mode pressing key
05/2011
LE
HD / HD is a portable instrument powered by one 7.2 V
LE
external DC charger
HD side panel. Connect the DC charger to the mains. Then,
LE
[1] for more than two seconds. The level meter is now in
BATTERY CHARGE STATUS
OFF
< 50 %
> 50 %
100 %
[12]. These are the indicators on screen:
to EXT. SUPPLY
ON
< 90 %
> 90 %
100 %
[32] on the
Page 13