Service Indicator; Technical Data; Slitting Tool - Hilti DCH 150­SL Manual De Usario

3.4

Service indicator

The slitting tool has an LED service indicator.
Status
The service indicator flashes red.
The service indicator lights up when the power tool
is in working order.
The service indicator lights up when the power tool
is not in working order.
3.5 Items supplied
Slitting tool, pin wrench, slitting discs, break-out tool, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group
4

Technical data

4.1

Slitting tool

For rated voltage, rated current and/or power, line frequency and rated speed, refer to the country-
specific type identification plate.
Information for users as per EN 61000-3-11: Switching on causes a brief drop in voltage. Other appliances
may be negatively affected on mains supplies where conditions are unfavorable. No malfunctions are to be
expected on mains supplies with an impedance of <0.15 ohms.
Weight in accordance with EPTA procedure 01
Arbor diameter, disc mount
Thickness of the diamond slitting disc
Diameter of the diamond slitting disc
4.2 Noise information and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions have been measured in accordance with
a standardized test and may be used to compare one power tool with another. They may be used for a
preliminary assessment of exposure.
The data given represents the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools or is poorly maintained, the data may vary. This may
significantly increase exposure over the total working period.
An accurate estimation of exposure should also take into account the times when the power tool is switched
off, or when it is running but not actually being used for a job. This may significantly reduce exposure over
the total working period.
Identify additional safety measures to protect the operator from the effects of noise and/or vibration, for
example: Maintaining the power tool and accessory tools, keeping the hands warm, organization of work
patterns.
*2208335*
Meaning
The motor has overheated. Allow the power tool to
run under no load so that it can cool down quickly.
When the power tool has cooled down the ser-
vice indicator goes out and the motor shuts down.
Restart the power tool by switching it off and then
on again.
•
•
•
•
2208335
The carbon brush wear limit has almost been
reached. You can continue working for a number
of hours after the indicator first shows, before
automatic cut-out is activated.
The carbon brushes have been changed and
must be run in by letting the machine run under
no load for at least 1 minute without interruption,
in order to achieve the optimum service life.
The carbon brushes are worn and have to be
replaced.
The device is defective.
7.6 kg
22.2 mm
≤ 3 mm
≤ 150 mm
English 19