Cutting Through A Workpiece; Switching On And Off; Transport; Switch Trigger Lock - Metabo CS 23-355 Instrucciones De Manejo

17026873_0511 CS 23-355 NAFTA.book Seite 8 Dienstag, 17. Mai 2011 1:18 13
ENGLISH
ENG
6.3

Cutting through a workpiece

Danger of crushing! Do not reach into the
area of the joint when lowering the lever!
• Do not begin cutting until the machine has
reached its maximum rpm.
• Slowly lower the cutting disc onto the work-
piece and conduct the cut with little contact
pressure.
• After finishing the job, put the lever into the
starting position.
• After a complete cut, switch off the machine,
allow the motor to come to a complete standstill
and only then prepare the next cutting job. The
removal or insertion of workpieces while the
cutting disc is rotating can lead to injury.
• Do not work with too much contact pressure,
since the cutting disc can otherwise quickly
become worn out, or the machine or workpiece
can be damaged.
6.4

Switching on and off

Switching on: Press and hold blocking device
(10), actuate switch (9).
Switching off: Release the trigger (9).
6.5

Transport

For transport, turn the lever (5) all the way down
and stop by actuating the transportation lock (4).
Note: To lock the lever, it is necessary to turn the
cutting depth limiter (3) to a lower position. See
section 6.1.
6.6

Switch Trigger Lock

To prevent unauthorized use of the product, install
a padlock through the hole of the switch. When the
lock is installed and locked, the switch is
inoperable. Store the padlock key in another
location.

7 Maintenance

Disconnect the mains plug before starting
any conversion or maintenance work!
Engage the spindle locking knob (8) only
when the motor is inoperative.
8
8
Removing the cutting disc:
- Press lever for spindle locking knob (8) to the
right and turn the cutting disc by hand until the
spindle locking knob is felt to engage.
- Use the wrench (c) to remove the screw with
clamping flange (b) anti-clockwise.
- Remove cutting disc.
Fitting the cutting disc:
- Use recommended disk only, Refer to
section 9 Accessories.
- Put on new cutting disc (a).
- Fit the screw with clamping flange (b).
- Use wrench (c) to lock spindle and tighten screw
with clamping flange (b).
- Check whether the spindle locking knob (8) is
completely disengaged again.
- Clean the dirty machine and remove the grinding
dust.
Regular maintenance:
Oil the following parts at least once a month:
movable parts of the vice.

8 Troubleshooting

Switching on procedures produce brief reductions
in voltage. Unfavourable power conditions can be
detrimental to other devices. Power impedances
smaller than 0.2 ohm should not cause any
malfunction.

9 Accessories

Use only genuine Metabo accessories.
Use abrasive wheels only, which meet this
specification:
- Type 1 cut-off wheel
- Rated speed 4100 rpm or higher
- Max diameter 14" (355 mm)
- Thickness 3/32" (max 3,2 mm)
- Arbor hole 1" (25,4 mm)
For a complete range of accessories, see
www.metabo.com or the main catalogue.
For USA accessories please visit
www.metabousa.com or see U.S. main catalogue.
a b c