Maintenance; Accessories; Fitting The Circle-Cutting And Rip Guide - Metabo ST 50 Pendix Instrucciones De Manejo

9 Maintenance

Be aware of the danger of injury
represented by the sharp saw blade.
All maintenance operations must be carried
out with the saw blade at rest. Switch off
the jig saw and disconnect from the mains
supply.
Clean the air intake aperture behind the
grooved roller supporting the saw blade. From
time to time lubricate the roller with a drop of
oil.
Have the carbon brushes replaced by the
manufacturer or in an appropriate specialist
workshop only.

10 Accessories

Use original Metabo accessories only.
Your Metabo dealer will supply you with any
accessories you may require.
To assist in selecting the correct accessories,
make sure that you take a note of the exact
model of your tool for your dealer.
Accessories available (page 4):
A Jig-saw blade
B Clip-on plastic plate for fitting to the
footplate of the jig saws to protect delicate
workpiece surfaces from scratching.
C Spare anti-splintering footplate inserts
D Circle-cutting and rip guide
E 35 mm dia. vacuum extraction hose
F Jig-saw guide for using jig saws in
conjunction with the guide rail
G Guide rail, 1500 mm long
H G-clamps
I Jig-saw bench-mounting plate,
255 x 183 mm with clamp for fixing the
plate to the workbench

10.1 Fitting the circle-cutting and rip guide

For sawing circles of between 100 mm and
360 mm dia. and for cuts parallel to an edge
(max. 210 mm).
Fit clamps
19
20
M+P-14A-
Locate the clamps (19) with the opening to the
front and the thread hole to the top on the
footplate (10) and tighten the screws (20),
turning from the underside.
Ensure that you remove the clamps
holding the circle-cutting and rip
guide after use, as otherwise the saw-
blade clamping device may be
damaged when making bevel cuts.
Fitting the circle-cutting guide
19
20
M+P-14A-
Slide the circle-cutting and rip guide (21) into
the clamps (19) on the footplate (10). Set
dimension (a). Turn the screws (20) tight.
ENGLISH
21
10
a
c
17