Publicidad
Vehicles with curved raised rails may require more pitch adjustment. Assess your
vehicle beforehand and do not use the plates in TimberLine step 5 if necessary.
1
REMOVE COVERS.
Squeeze
and pull to
remove the
covers.
3
BACK OUT BOLTS AND RELEASE STRAPS.
Using the torque wrench or a cordless
drill, loosen the lower adjustment screw
on each tower about 50 turns until the
straps can be lifted out of the cradle.
Press against the backside of the strap
and lift out of the cradle as shown.
INSTALL THE
4
ADAPTERS.
Snap the
adapters
into place.
"Snap"
2X
Instruction #1036004A - Page 2 of 9
2
LOOSEN THE ADJUSTMENT SCREW.
Use the 4mm
torque wrench
supplied with your
TimberLine towers
to loosen the
upper adjustment
screw 8 turns.
2X
5
INSTALL THE BRACKET AND PLATES.
Install the bracket from your LockNLoad Platform,
the plate, and nut insert as shown. Tighten the
bottom screw and the upper front adjustment
screw to 3.5 Nm using the torque wrench.
"Click!"
"Click!"
"Click!"
3.5 Nm
8X
2X
2X
3.5 Nm
"Click!"
"Click!"
"Click!"
2X
Publicidad
