Publicidad
6
INSTALL THE MOUNTING BLOCKS.
Align the mounting block from
the LockNLoad platform with
the bracket. Then thread two
M6 x 16mm capscrews from the
platform hardware and tighten to
3.5 Nm using the torque wrench.
NOTE: The mounting block
assembly will still have movement
after tightening the screws.
ATTACH TOWER AND MOUNTING BLOCK ASSEMBLIES
7
TO THE VEHICLE RAISED SIDERAILS.
Note: Second pair of mounting block assemblies are for reference only. Additional adapters sold separately.
Route the
straps around
your siderails
and e-engage
the straps then
tighten the
bolts until the
assemblies are
stable on the
rails but DO NOT
TIGHTEN them
completely.
Continue with your LockNLoad Platform instructions to complete your Platform installation.
Instruction #1036004A - Page 3 of 9
Place the Timberline tower and mounting
block assemblies on top of the rail, ensuring
that the hole on the underside of the assembly
is positioned directly on top of the rail. Check
that the strap can pass underneath the rail
and re-engage with the cradle. If not, back off
bolt shown in Step 3 further.
3.5 Nm
"Click!"
"Click!"
"Click!"
2X
2X
Publicidad
